top of page

Program Your Timer

To program your timer, please follow these steps in order.
If you have an issue, please email us at easyautojig@gmail.com.

 

1. Take the lid off

2. Hold the machine in your left hand

3. Turn the knob on the bottom of the machine to the right; this knob turns the machine on and off as well as controls the speed at which it operates

4. With the machine on and the timer running, press and hold the SET button (second button from the left) just long enough the finish reading this sentence. 

5. You will see P 3.2 on the LED display

6. Quickly push the same set button and let go immediately

7. You will see OP flashing on the LED display, followed by three-digits which designate the run-time for your device

8. Using the right two buttons, you can increase or decrease the time you want the machine to operate in the jig mode

9. Quickly press the SET button again; you will see CL on the LED display

10. Using the right two buttons, you can increase or decrease the off time for your machine

11. Long press the SET button again until P 3.2 is flashing on the LED display

12. Your machine is now running as you programmed it

Buy now on Amazon!

bottom of page