EASY CATCH

Instructions and History

Our Story

Available.......

While They Last!

Thanks for looking!

  You ARE interested and do well to read up on this machine. 

​

"To set the timer" directions:

Directions are located on the drop down menu, top right up there.  

​

These directions also come with each unit, enclosed in it's shipping container. The Easy Catch sticker and another swivel are free. 

​

​ Silly comments on FB are amusing, but the bottom line is:

Easy Catch works, it is solid,

as well as being inexpensive. 

Started up in late 2022, Easy Catch Auto Jig is something new for 

 ICE FISHING.

​

It's a one of a kind machine that EASILY attaches to most tip-ups.

This machine has a few videos on YouTube, under the name "Easy Catch Auto Jig", as well as on FB group page videos, using the same name.

Facebook page name Easy Catch Auto Jig and may be likely where you discovered the link for this site THANKS!

​

The machine comes with a USB charge cable, a 1..5mm Allen wrench, to ensure that the set screws that attached the arm to the machine stay snug, A single mounting screw to position the device where it will operate without interference on your tip-up, also allowing the machine to swing clear of the tip-up when it is folded up for storage. We send two, but one will give advantage of easy storage by allowing the machine to swing clear.

This unit also comes with 1 ball bearing swivel with a hook snap, attached onto a #3 swivel.

Also, the device comes with a USB charger.

Do not leave this charger plugged in to a power source longer than three hours. It takes no longer than that to reach full charge.  Untether it from the unit as well when not charging or it will drain the battery. 

​

Easy Catch is simple to attach:  Just remove the latched cap from the machine, position it onto your tip-up, where the machine will have clearance to operate while the tip-up is over the ice hole. 

Drill a single pilot hole through the top and into the tip up and screw the latching top to the tip-up.

Snap the machine in place, insert your tip-up line, by passing it through the ball bearing swivel, attach YOUR hook onto the end of the line, and away you go!

​

Or, use your imagination!

There have been ones who use duct tape, Hot glue will affix the unit onto a shelf or bracket close to a rattle reel inside a shanty. 

Turn it on and NOT hear it run!

​

Through discovery, we realized that the Easy Catch Auto Jig can also be attached onto a cane pole or a traditional fishing rod..

This is accomplished by attaching the lid to the pole using zip ties.

Slots can be melted or drilled through the lid to allow the passage of zip ties..

​

Engineered with a silent drive, it can be used INSIDE of an ice castle and not bother everyone with whining or any clunking sound when it is in operation.

​

This machine has been in development for over 4 years; Easy Catch was made as dependable as possible.

The inexpensive price was made possible because of the time it took to source parts directly from manufacturers. 

The Easy Catch Auto Jig is engineered using a USB rechargeable battery, good for 500 cycles. The battery has been tested and proven to operate at sub zero temperatures, as will the motor and electronics. The battery has an extremely long run time, well over 12 hours, and If you have any problem with it, simply return it for a replacement and we'll cover postage.

​

FINALLY...ice season is HERE so now is the time to get one as supply will be likely be limited, as they were last year,

​

This widget WILL change your catch rate on the ice and NOT break the bank! 

We have some videos on YouTube and FB Group Page:

Easy Catch Auto Jig

THANK YOU FOR VISITING!

​

Buy now on Amazon!

​